Document 11012345
Frequently Asked Questions (FAQ)
Document 11013568
Some vehicles may exhibit a deformed fuel-filler lid panel (1) attached to the fuel-filler lid box, resulting in a poor appearance. This concern is caused by the lid box not having enough water drainage capability which leads to the accumulation of water inside it. The water then freezes in cold weather and expands or the inner side of the lid panel absorbs the water and swells from long exposure, deforming the lid panel. To eliminate this concern, the shape of the fuel-filler lid box has been modified to have better drainage capability and a modified fuel-filler lid panel service part has been established for less water absorbance.
Document 11013572
Customers may report no audio when using the infotainment fader function fully adjusted to the rear. If the customer's vehicle is among the trim levels referenced above it is equipped with a 6-speaker infotainment system and does not include rear door speakers even though there are speaker grills/covers in the rear door panels. MazdaUSA and published vehicle specifications provide the correct information indicating that these trims are equipped with a "6-speaker audio system". This is a normal condition of the "6-speaker audio system" and current Mazda CONNECT fader function. Rear speaker diagnosis is not necessary as they are not equipped.
Document 11013654
Some vehicles may exhibit wear/peel-off of the leather steering wheel surface causing a poor appearance. This concern may be caused by an insufficient wear resistance of the steering wheel surface.
Document 11013787
When performing the MGSS Workshop Manual 360 View Monitor System Aiming Procedure, M-MDS may show error message "Procedure unsuccessful". This may be caused by light glare on the SST.
Document 11013788
Key Transmitter Power Saving Function: When the key transmitter Power Saving Function is turned ON, transmitter battery power consumption is restricted, thereby extending the transmitter battery life. NOTE: Some customers may complain about an engine no start. This may be caused by the customer inadvertently putting the key transmitter in Power Saving Function.