Document 11012010
FUEL VAPOR CANISTER FILTER EVAP Fuel Filters are to be checked for restriction / blockage on a regular schedule as indicated in the Owner s Manual. If the Filter is restricted or blocked then replace the part. For customers that drive light duty trucks in extreme dusty and dirty road conditions, please reference information only TSB 25-009-24 for an available MOPAR Dual EVAP Filter kit that is customer paid.
Document 11012777
Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On
Document 11012824
"Internal Transmission Wiring Connector Short Warranty Extension XN1 This bulletin involves replacing the transmission. *Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs):** P0A3F - Drive Motor A Position Sensor 1 Circuit. P0A43 - Drive Motor A Position Sensor Circuit Intermittent. P0A45 - Drive Motor B Position Sensor 1 Circuit. P0C1A - Drive Motor B Torque Delivered Performance. Customers may also comment on the following: Vehicle is in limp mode. Module flashes are also required for this Repair Procedure to be effective, the following modules are to be updated: Hybrid Control Processor (HCP). Auxiliary Hybrid Control Processor (AHCP) also known as the Power Inverter Module (PIM "
Document 11012884
Door Latch, Handle And Ajar Additional Service Information.
Document 11013171
Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS Related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On
Document 11014231
"3.6L PSU Long Block Misfire DTC codes and/or rough idle and/or valvetrain noise. These conditions may be related to worn intake camshaft high lift lobe(s), and intake rocker arm(s) high lift slider. High mileage failure (10,000-60,000 miles). 1. Remove the valve cover(s) per the released service procedures. The use of a stethoscope or DTC specific cylinder misfire codes can help to locate the condition to the left or right bank. 2. Once it has been visually confirmed that there is wear on the high lift intake lobe(s) & rocker arm(s) slider, there is a special service kit for this type of repair which should be used, instead of replacing the complete engine/long block. This kit contains the parts required for the repair (intake cam, rocker arms, sealer and gaskets)."