Document 11012342
Some customers may experience the following symptoms of the wireless charger (Qi), even when the mobile device (smartphone etc.) is placed in the proper position on the wireless charger (Qi). It does not start charging. It stops charging with the indicator flashing in red after starting. It stops charging without any visible sign after starting. For CX-50, some customers may experience that despite placing the MagSafe-equipped iPhone at the center of the wireless charger, charging stops after about ten seconds. MagSafe-equipped iPhones use magnets to align the charger and the device. When charging MagSafe-equipped iPhones with a non-MagSafe compatible charger, improper alignment can cause the magnetic field required for charging to be disrupted by the magnets, significantly reducing charging efficiency.
Document 11012344
Mazda Motor Corporation has decided to conduct a Special Service Program (SSP) to extend the warranty coverage for a specific repair of the fail-safe thermostat installed inside of the suspected coolant control valve on certain 2018-2025 CX-5, 2019-2023 Mazda3, 2019-2022 CX-3, 2018-2021 Mazda6 and 2020-2023 CX-30 vehicles. The warranty coverage for an applicable repair has been extended to 15 years (180 months) /150,000 miles (240,000 km) whichever comes first, from the original warranty start date. If you are a recipient of this notice, your vehicle is included in this warranty extension program. What is the problem? On certain subject vehicles, the check engine light is illuminated with diagnostic trouble code (DTC) P0126, due to the fail-safe thermostat being stuck open. Additionally, you may notice one or more of the following symptoms: -Engine takes longer to warm up. -Engine temper
Document 11012345
Frequently Asked Questions (FAQ)
Document 11013567
Some vehicles may experience "Blind Spot Monitoring Sensor(s) Blocked" displayed in the instrument cluster while driving over 37 mph {60 km/hr.} in areas without structures or buildings around the vehicle. This may be caused by a partial defect in the blind spot monitoring (BSM) control module. To eliminate this concern, the blind spot monitoring (BSM) control module has been modified.
Document 11013654
Some vehicles may exhibit wear/peel-off of the leather steering wheel surface causing a poor appearance. This concern may be caused by an insufficient wear resistance of the steering wheel surface.
Document 11013655
Some vehicles may exhibit a partially missing image (shown in the circles below) from the Active Driving Display (ADD) on the front window and/or display.