Document 11018580
Some vehicles may exhibit a loss of connectivity or interruptions in the middle of using Connected Car Services (CCS) functions. This may be due to an occasional disconnection on Verizons communication network. Follow the procedures in this bulletin to verify Connected Car Data Communication Unit (DCU) network connection and if needed, reset the DCU in Dealer Mode to resolve the connection.
Document 11018880
Certain 2025MY GV80 and GV80 Coupe (JX1) vehicles equipped with the 3.5T-GDI Lambda III engine may NOT experience a warning lamp illumination of DTC P0461/P2066 when the calculated fuel consumption and the fuel consumption calculated from the fuel level sensor signal is over its threshold value.
Document 11018881
Certain 2025MY GV80 and GV80 Coupe (JX1) vehicles equipped with the 3.5T-GDI Lambda III engine may NOT experience a warning lamp illumination of DTC P0461/P2066 when the calculated fuel consumption and the fuel consumption calculated from the fuel level sensor signal is over its threshold value. Follow the service procedure outlined in this bulletin to update the engine control module to revise the fuel level sensor warning light logic.
Document 11019526
The California Air Resources Board has determined that certain 2025 model year Genesis GV80 and 2025 model year Genesis GV80 Coupe vehicles may be releasing air pollutants which exceed Federal and California standards. Genesis has become aware that some vehicles may NOT experience a warning lamp illumination related to the fuel level sensor circuit. Your Genesis retailer is conducting a service campaign to update the Engine Control Module (ECM) to improve the Fuel Level Sensor Logic.
Document 11019685
Some GV80 (JX1) vehicles may exhibit a rubbing/dragging noise when rotating the steering wheel due to a misaligned clock spring. Airbag operation is not affected. Follow the procedure in this TSB to inspect and, if necessary, replace the multifunction switch.
Document 11023409
Some vehicles may exhibit a rubbing type noise when turning the steering wheel. Follow the procedure in this TSB to inspect the source of the noise and, if necessary, replace the Steering Shaft Dust Cover.